Construction Adhesives

Application Guidelines

Application Temperature:

40°F to 100°F (5°C to 38°C)

Service Temperature Range:

10°F to 120°F

Working Time:

Approximately 20 minutes for a 1/4” bead

Prep:

Surfaces must be clean and free of any material that may prevent adequate adhesion.

Application:

Cut tip on slant for 1/4” to 3/8” bead. Puncture inner seal and place in cartridge gun. Apply adhesive to one of the surfaces in either a continuous or spot bead. Paneling or foam: Apply 1/4” bead around perimeter 1” from edge and two zigzag beads in middle. Framing members: Apply directly to studs. Press materials firmly together with a slight twisting motion. Nail as needed. Drywall: Use fasteners in accordance with local building standards. Note: For large panels, bracing may be required until adhesive dries.

Cleanup:

Tools and adhesive may be cleaned with water while the adhesive is wet. If dried, tools and adhesive may be cleaned with water/acetone/vinegar mixture. Follow solvent vendor’s precautions.

Limitations:

Not designed for continuous submersion. One surface must be porous. For best results, store above 40°F.